![]() ![]() After establishing a right angle, do your measurement to correspond with what is on the plan and then use the square at the other end to now establish the other two points.the rope running through two pegs from the rear to the front either on the left side or the right side. To determine if your rope is at the right angle put a checker popularly called ‘square’ by bricklayers, this will direct you if you need to shift the other rope that can be varied since one is already fixed to form a base mark (i.e. Measure the setback from the fence establish these two points with pegs then put a rope to cross both pegs and make them form a right angle or 90 degrees. After this go back to the rear or you may use the front as a point mark depending on which setback is more important to you.Taking just one side measure the setback from the back of the fence to the end of building lines in that particular angle, then come to the front and measure the setback also as given on your drawing plan.After establishing these four corners insert nails at the centre- top of each peg and then run rope round the 4 pegs.Establishing the four corners in relation to the dimension of the building floor plan by pegging it.Firstly, take note of the four corners where we have the proposed columns/pillars or as the case might be.pegs, nails, rope or line, hammer, tape, marking tool etc) Get the necessary materials ready (i.e. ![]() Here, we discuss setting out using pegging Setting out Steps ![]() Steps for Designing Machine Setting Out Methods ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |